Hole in a Plane of Charge:
A large flat non-conducting surface
(treat it as an infinite sheet)
carries a uniform charge density
C/m2.
A small circular hole has been cut out of the middle of this
sheet of charge, as shown on the diagram.
Calculate the electric field at point P a distance
z = 1.0 m
up from the centre of the hole along its
axis. The radius of the hole is
R = 0.4 m.
2.
3.
4.
CAPACITOR WITH INSERT:
Suppose we have a capacitor made of two large flat parallel plates
of the same area A (and the same shape), separated by an air gap
of width d. Its capacitance is C. Now we slip another planar
conductor of width d/2 (and the same area and shape)
between the plates so that it is centred halfway in between.
What is the capacitance
of the new system of three
conductors, in terms of the capacitance C of the original pair
and the other parameters given?
(Neglect ``edge effects'' and any dielectric effect of air.)
0.4in
. . . and
Tipler (4 Edition)
Ch. 24: problems
19, 49, 65 and 97
Ch. 25: problems
33, 54, 57, 67, 101 and 109
Challenge Problems:
1.
THUNDERCLOUD CAPACITOR:
A large thundercloud hovers over the city of Vancouver at a height of
2.0 km. Between the cloud and the ground
(both of which we may treat as parallel conducting plates,
neglecting edge effects) the electric field is about
200 V/m. The cloud has a horizontal area of
200 km2.
(a)
Estimate the number of Coulombs [C] of positive charge
in the cloud, assuming that the ground has the same surface density
of negative charge.
(b)
Estimate the number of joules [J] of energy
contained in the air between the cloud and the ground.
2.
CUBIC CAPACITOR:
Suppose we take a roll of very thin (
50 m) copper sheet and a roll of
150 m thick strontium titanate dielectric
(dielectric constant 310)
and form a capacitor as follows: cut the sheets into strips
5 cm wide and sandwich the dielectric sheet between
two sheets of copper. Then fold the sandwich back and forth
to fill a cube
5 cm on each side. Assuming that we can press the layers
together firmly so that there are no empty spaces, find:
(a)
the capacitance of the resulting cube-shaped capacitor;